————————————————————
#2 UNPACKING YOUR EQUIPMENT
————————————————————
2.1
If your system’s protective packing
is damaged upon delivery you
should photograph the damage
and remove the contents for
inspection before signing the
delivery note. There will 2 or 3 boxes
depending on the model you have
purchased.
2.1.1 Quatreau SmartTap™ (faucet)
2.1.2 Quatreau Boiler
2.1.3 Quatreau Chiller / Chiller Carbonator
2.2 Open and inspect the Quatreau
SmartTap™ to inspect the
components and installation kit. Use
the packaging to prevent damaged
until ready to
fi
t to work surface.
2.3 Open the top of the Quatreau
Boiler (QST553-B) box and remove
the top protective layer. You will see
two protruding opaque stems, be
careful not to damage these outlets.
2.4 Cut down each side of the box
to reveal the system so that you
don’t have to lift it out of the box. The
boiler will be installed on the
right-hand side of the cupboard
after you’ve installed the SmartTap™.
This item weighs 44lbs. Please take
care when moving or lifting, the
sides and corners are hard and will
damage furniture if knocked.
2.5 Leave the system on the protective
packaging until ready to install.
2.6 Open and inspect the chiller
carbonator, leave in its base until
ready to install.
————————————————————
————————————————————
#3 INSTALLING THE
QUATREAU
SMARTTAP™
————————————————————
3.1 NOTE THAT THE TAP MUST BE
SITED ABOVE OR ADJACENT
TO THE QST553-B (BOILER
CONTROL UNIT), CLOSE
ENOUGH SO THAT THE
COMMUNICATION CABLE
FROM THE SMARTTAP™ IS
NOT STRETCHED WHEN IT
PLUGS INTO THE BACK LEFT
SIDE OF THE BOILER.
————————————————————
3.2
THE QUATREAU SMARTTAP™ will come
as a stand-alone tap or integrated
into a drip-tray. With the relevant
cutting template enclosed with your
product choose the most suitable
position for the tap.
3.3 Depending upon the surface you will
need special cutting equipment. For
granite or marble a diamond tipped
core bit will be required. For wood or
MDF or polymer type surface a
wood bit will normally be adequate.
Always check with the worksurface
manufacturer and ask what type of
bit can be used.
3.4 Decide where the tap is going to sit.
Note that the control panel on the
drip tray is on the right-hand side of
the tap. Ensure that the location you
choose is suitable and that you can
reach the controls without needing
to stretch whilst ensuring that the user
will not have to reach through the
stream of water to operate the tap.
Your kitchen design will of course
dictate where you can install it
safely.
I N S TA L L AT I O N