————————————————————
#5 INSTALLING THE VENTILATION FOR
THE CHILLER UNIT
————————————————————
Ventilation will ensure your chiller
performs to its speci
fi
cation. Failure to
install this will void the warranty on this
module.
5.1 Inside the packing you will
fi
nd
cutting templates. Chose the CS20
base and front grill.
5.2 Drop the kick board and check
underneath the left side of the
cupboard for any pipes or electrical
wires that may be in the way. Ensure
they are moved before starting to
cut the ventilation.
5.3 locate base cutting template inside
the left side of the cupboard, mark
the 4 corners and cut the ventilation
hole into the base.
5.4 install the vent kit steel angle piece
provided and insert the vent duct so
that it runs to the front of the
cupboard. Mark off the point where
it crosses the kickboard and cut to
length using a suitable hand saw.
5.5 Using the template for the kick board
vent grill mark the location for the
screws and cut out area and cut
out.
5.6 Fix grill to front and replace the kick
board so that it marries up with the
vent duct.
————————————————————
————————————————————
#6 CONNECTING WATER SUPPLY
————————————————————
6.1 Connect the John Guest 1/2” - 1/4”
reducer from the installation kit to the
cold isolation valve
6.2 Connect the blue ¼” tube found in
the installation kit to this ¼”
connection on the mains supply
(push in
fi
rmly) then cut it at a length
that extends to the front of the
cupboard where the Boiler inlet will
sit.
6.3 Attach the ¼” isolator valve from the
fi
tting kit and add a 6” piece of blue
pipe onto its outlet.
6.4 Now slide the QST553-B (the boiler)
into place on the right side of the
cupboard. Connect the ¼” pipe
from the isolator into the front
right-hand side port.
6.5 Now turn on the mains water supply
and open the isolator, check the
connections are Water-tight.
6.6 In your installation kit you will
fi
nd a
length of silicon hose with a
VenturiT™ connector. Connect the
shortest length (above the T) to either
of the 2 pipes protruding from the
base of the spout ensuing you have
located the spring clip
fi
rst. NOTE
Only push the silicon upwards onto
the pipe – do not pull the pipe down
to join it or you’ll risk disconnecting it
from the spout tip.
6.7 Connect the other end to the rear
spigot sticking up at the back of the
boiler unit. Do this by cutting the
length back so that you don’t have
too much pipe in use. The run should
be as log as necessary to make a
I N S TA L L AT I O N