Cable Replacement
Page 80
AirborneDirect™ Serial Bridge User’s Guide
100-8006-152G
Quatech, Inc. Confidential
Table 15. Master Configuration and Set-up
Description
Setting
Web or
ACC page
CLI Command
1
Set the SSID of the unit to the
name of the AdHoc network
AdHoc Network Name
Network
wl-ssid [AdHoc Network
Name]
2
Set network type to AdHoc
(Infrastructure is default)
AdHoc Network
wl-type p
3
Set AdHoc Channel
1
Network
wl-chan 1
4 Disable
DHCP
Disable
Network
wl-dhcp 0
5
Assign a static IP
(Slave a 1)
192.168.10.151 Network
wl-ip 192.168.10.151
6
Assign a network mask
255.255.255.0
Network
wl-subnet 255.255.255.0
7
Set the Primary LAN Server IP
Address to match the slaves static
IP address
192.168.10.150 Serial
wl-tcp-ip 192.168.10.150
8
Set the LAN Server port to match
the tunnel port on the slave
8023 Serial
wl-tcp-port 8023
9
Configure the serial port settings
to match the attached system
Baud Rate = 9600
Data Bits = 8
Parity = None
Flow Control = Hardware (RTS/CTS)
Stop Bits = 1
Serial
Bit-rate 9600
data-bits 8
parity n
flow h
stop-bit 1
10 Set serial default mode to PASS
(CLI is default)
Pass Serial
serial-default pass
11 Save the settings and restart the
unit.
Save and Restart
Reset
commit
restart
Note:
All parameters values are included for the purpose of demonstration only.
Although valid, they should be changed to meet the application
requirements.
As long as the slave device is on and is waiting for the connection, the master will boot and
establish a TCP/IP connection with the slave. The slave will accept the connection and a serial-
to-serial data tunnel will be established between the two units. Once the tunnel is established
data can be sent between the two devices.
