Airborne Control Center
100-8006-152G AirborneDirect™
Serial Bridge User’s Guide
Page 45
Quatech, Inc. Confidential
Authentication
Defines the type of key authentication, if any, to be used:
•
Automatic
– automatically detects the authentication
(
default
)
•
Open System
– communicates the key across the
network
•
Shared Key
– allows communication only with devices
with identical WEP settings
Default Key
Default WEP Key from 1 – 4 if
Shared Key
or
Both
is
selected for
Authentication
.
Default is
WEP Key 1
.
WEP Key 1 through 4
Up to four WEP key values. These values must be the same
as the key implemented by the Access Point.
•
If
WEP Encryption
=
64
, enter 10 hexadecimal digits for
each key.
•
If
WEP Encryption
=
128
, enter 26 hexadecimal digits for
each key.
Enable WPA Information Element
format compatibility mode
Controls the format of the WPA Information Element used in
the Association Request management frame. Several brands
of Access Points still use the legacy WPA format.
When
unchecked
, enables the Legacy WPA Information
Element format.
When
checked,
enables the 802.1x WPA Information Element
format.
Default is
unchecked
.
Parameter
Description
Advanced Settings
Module MAC Address
Bridge’s MAC address. Default is factory set.
Do not change
this value; otherwise, unexpected results can occur
.
Antenna Mode
•
Ant2
– use primary antenna (J2)
(default)
•
Diversity
– allows the Bridge to select the antenna
receiving the best quality signal.
Maximum Transmission Rate
Bridge’s maximum wireless transmission rate. The Bridge will
attempt the highest specified rate and fallback to a lower rate if
necessary. Default is
5.5 Mbps.
