Preliminary
4-15
September 21, 1999
BENCHMARK
T A P E
S Y S T E M S
3. Press
the
NEXT
or
PREVIOUS
button to scroll through the destination slot choices.
Press
SELECT
when the desired destination slot is displayed. If the destination slot
already contains a cartridge,
RESELECT
blinks on the LCD panel. Select a different
destination slot.
Your DLT7 Autoloader moves the cartridge and displays
LdR REAdY.
4.4.6 Mode 5 – DENSITY
Cartridge density is fixed and cannot be changed. This mode is not valid.
4.4.7 Mode 6 – SET SCSI
This Mode sets the SCSI ID of the robotics and/or the drive.
Note:
SCSI ID changes are not effective until you cyclepower on your DLT7 Autoloader.
To access
Mode 6
:
1. Press
the
Mode
button on the operator’s panel repeatedly until
Set SCSI (Mode 6)
appears on the first line of the LCD panel.
2. Press
the
Select
button to enter SCSI ID setting mode.
LdR SCSI
appears on the LCD
panel.
3. Press
the
Select
button to select the SCSI ID for the autoloader robotics.
LdR Id x
–
where
x
indicates the current SCSI ID of the autoloader robotics – appears on the LCD
panel.
4. Press
the
Next
button to select the next higher SCSI ID. Press the
Previous
button to
select the next lower SCSI ID. Repeat this process until the desired SCSI ID appears on
the LCD panel.
5. Press
the
Select
button to set the new SCSI ID for the autoloader robotics.
dRV Id x
– where
x
indicates the current SCSI ID of the autoloader robotics – appears on
the LCD panel.
6. Press
the
Next
button to select the next higher SCSI ID. Press the
Previous
button to
select the next lower SCSI ID. Repeat this process until the desired SCSI ID appears on
the LCD panel.
7. Press
the
Select
button to set the new SCSI ID for the drive.
CYCLE PWR
(blinking) appears on the LCD panel for approximately 10 seconds.
8. Press and hold the
Power
button for approximately two seconds to turn off your DLT7
Autoloader.
9. Wait a few seconds, then press the Power button again to turn on your DLT7
Autoloader.
The selected SCSI IDs are now in effect.
Note:
You may also need to cycle power on the host server or workstation and reconfigure
your backup software before you can use your DLT7 Autoloader.
