Quantum ATL 7100, Installation Manual, Page: 48 / 68

Chapter 3 Installing the Library
Preparing the Library for Operation
32 Quantum|ATL 7100 Series Facilities Planning and Installation Guide
Preparing the Library for Operation
3
After the library is installed and connected to the host, you can
perform the procedures listed below as needed to prepare the
library for operation.
For a description of how to perform these procedures, refer to the
Quantum|ATL 7100 Series Tape Library Operator’s Guide.
• Defining the library power-up state
• Enabling/disabling the auto clean option
• Enabling/disabling the auto load option
• Setting the language used for the status display area
• Enabling/disabling 4/52 identity mode
• Loading the library with cartridges (either through the load
port or by bulk loading of cartridges through the storage array
door)
• Performing an inventory
• Turning the interior light on or off