Quantech QTC3040T, Installation Operation & Maintenance

Page: 45 / 190

45
QUANTECH
FORM QTC3-NM1
ISSUE DATE 08/03/2022
55
OPERATIONAL LIMITATIONS (ENGLISH)
SECTION 5 – TECHNICAL DATA
TABLE 4 -
TEMPERATURES AND FLOWS
UNIT
DESIGNATION
TEMPERATURE
WATER FLOW
(GPM) MIN
WATER FLOW
(GPM) MAX
AIR ON CONDENSER (°F)
MIN
1
MAX
2
MIN
3
MAX
4
STANDARD EFFICIENCY
QTC3070TSE 40 55 60 285 -10 125
QTC3075TSE 40 55 100 355 -10 125
QTC3085TSE 40 55 100 385 -10 125
QTC3095TSE 40 55 100 385 -10 125
QTC3110TSE 40 55 150 625 -10 125
QTC3125TSE 40 55 100 385 -10 125
QTC3140TSE 40 55 150 625 -10 125
QTC3160TSE 40 55 150 625 -10 125
HIGH EFFICIENCY
QTC3040THE 40 55 41 224 -10 125
QTC3050THE 40 55 48 224 -10 125
QTC3055THE 40 55 60 285 -10 125
QTC3060THE 40 55 60 285 -10 125
QTC3080THE 40 55 150 625 -10 125
QTC3090THE 40 55 100 385 -10 125
QTC3100THE 40 55 100 385 -10 125
QTC3120THE 40 55 100 385 -10 125
QTC3130THE 40 55 150 625 -10 125
QTC3150THE 40 55 150 625 -10 125
QTC3170THE 40 55 150 625 -10 125
QTC3205THE 40 55 230 625 -10 125
QTC3225THE 40 55 230 650 -10 125
NOTES:
1. For leaving liquid temperature below 40°F (4°C) (to 10°F [-12°C]) optional low temperature glycol kit required. Contact your
nearest Quantech Office for application requirements.
2. For leaving liquid temperature higher than 55°F (13°C), contact the nearest Quantech Office for application guidelines.
3. The evaporator is protected against freezing to -20°F (-29°C) with an electric heater as standard.
4. For operation at temperatures below 30°F (-1°C), install the optional Low Ambient Kit on the system.
5. For operation at temperatures below 0°F (-18°C), install the optional Low Ambient Kit with Variable Speed Fans on the system.
Excessive flow will cause damage to the
cooler. Do not exceed maximum cooler
flow. Special care should be taken when
multiple chillers are fed by a single pump.