Page
10
AN-X-TI-MAS
November 2011
1. Select the Ethernet adapter that is connected to the AN-X. In most
cases there will be just one Ethernet adapter in the computer. The AN-X
must be on the same subnet as the computer.
2. Enter the MAC address of the AN-X you are configuring. This is
printed on the AN-X label. It consists of six pairs of hexadecimal digits,
separated by hyphens. In the example above, it’s 00-0c-1a-00-01-c1.
If the AN-X is already online, you can obtain its MAC address using the
Utilities/Locate All AN-X Modules
command.
3. Enter the IP address you intend the AN-X to use. In the example
shown, it’s 192.168.1.10
Step 2
In step 2, you choose a method of restarting AN-X to put it in boot mode.
