AN-X3-GENI Page
11
Genius Cabling and Termination
Refer to
Genius I/O System and Communications User’s Manual
, GEK-90486F-1 for detailed
information on Genius cabling and installation.
The module has a 5-pin Phoenix connector for connection to the Genius I/O network. The part
number for the Genius bus connector is:
Phoenix 1757048
(Old part number: MSTB 2.5/5-ST-5.08)
Pin
Assignment
1
Not used
2
Shield out
3
Shield in
4
Serial 2
5
Serial 1
Ensure that the physical ends of the Genius I/O network are properly terminated. The AN-X
module does not have any internal termination.
WARNING!
Set the baud rate and serial bus address for the AN-X3-GENI module
before connecting it to the Genius network so the module does not
interfere with the existing nodes on the Genius network.
Ethernet Cabling
AN-X has a standard RJ-45 connector for connecting to Ethernet.
If you are connecting to the AN-X through a router or switch, use a standard Ethernet cable.
If you are connecting a computer or PLC directly to an AN-X3, you may need a crossover cable.
