123
•
Create replication job on the source subsystem
1.
If the license key is activated on the subsystem correctly, a new
QReplica
tab will be
added on the Web UI. Click
“Create”
to create a new replication job.
Figure 5.11.5
2.
Select the source virtual disk which will be replicated to the target subsystem and click
“Next”
.
Figure 5.11.6
Tips
If the message displays that there is not enough space for creation, please
refer to the section of
Configure the snapshot space
below for solution.
3.
Enter the IP address of iSCSI port on controller 1 of the target subsystem. Click
“Next”
to continue.
Summary of Contents for P300H61
