EN
QSR SERIES
USER MANUAL - REV000A
15
QSR series
• To adjust FC1 and FC2 end strokes, partially unscrew the fixing screw and move them to the right
or to the left based on need, then screw the fixing screw back on (fig. 21).
WARNING:
while adjusting FC1 and FC2 end strokes, verify that the cam which activates
them is always positioned between them and never in overstroke
.
•
Disconnect the QSR propeller from power for at least five seconds (fig. 22).
•
Connect power to the QSR propeller (fig. 22).
• Enable a QAJ control connected to the QSR thruster to open the lid and activate the thruster
(fig. 23).
• Disable the QAJ control before hand enabled in order to close the propeller
(fig. 23).
• Ensure that the high-absorption protection did not intervene (
the “ERROR” LED must be switched
off
- see section 5.7 fig. 19 / Part. C).
•
Open the thruster completely by switching it on by the remote
control
(fig. 23).
WARNING:
once the thruster is open, disconnect the
power supply (fig. 22) in order to lock it into this position
.
CAM 1
CAM 2
PLASTIC SUPPORT
PLASTIC SUPPORT
FIXING SCREW
SWITCH FC1
SWITCH FC2
ADJUSTMENT OF THE THRUSTER’S
MAXIMUM CLOSING
ADJUSTMENT OF THE THRUSTER’S
MAXIMUM CLOSING
CAM
5 - Installation
0FF
ON
fig. 22
fig. 21
Actuator’s interior
Opening of the actuator’s side lid
5.8 -
Actuator’s adjustment
fig. 23
• Insert the two end stroke wires in the proper slots.
• Position the two cable-stoppers, tension the two wires, checking
that both springs are equally pulled, tighten the cable-stoppers
by means of a 2,5 mm hexagon wrench key.
• Lock the cable-stopper by tightening the counter nut by means
of a 8 mm open end wrench, cut with a wire cutter the excess
cable leaving about 20 mm besides the cable-stopper.
• Power up the thruster (fig. 22) which will automatically close.
• In order to ensure that the thruster is properly working, open the
thruster several times using the control (fig. 23).
5.9 -
Installation of the springs’ end stroke wires
Fig. 24
QSR Ø185
QSR Ø250
Fig. 24
END STROKE
WIRE
CABLE
STOPPER
COUNTER NUT
SPRING
20 mm
MAX
END STROKE
WIRE
20 mm MAX
CABLE
STOPPER
COUNTER NUT
SPRING
Summary of Contents for QSR Series
Page 2: ......
