QNO FQR8030, User Manual

Page: 103 / 149

2WAN 4LAN Medium Scale Multi-WAN QoS Router
100
in a network, and if an administrator doesn’t want to assign a path list one by one to all of
the routers, RIP can help to refresh the paths.
RIP is a very simple routing protocol, in which Distance Vector is used. Distance Vector
determines transmission distance in accordance with the number of routers, rather than
based on actual session speed. Therefore, sometimes it will select a path through the least
number of routers, rather than through the fastest routers.
Working Mode: To select the working mode of the device: NAT mode or
router mode.
RIP:
Click “Enabled” to open the RIP function.
Receive RIP versions:
Use Up/Down button to select one of “ None
， ， ， ，
RIPv1
， ， ， ，
RIPv2
， ， ， ，
Both RIPv1 and v2
” as the “
TX
” function for
transmitting dynamic RIP.
Transmit RIP
versions:
Use Up/Down button to select one of “
None
， ， ， ，
RIPv1
， ， ， ，
RIPv2-Broadcast
， ， ， ，
RIPv2-Multicast ” as the “ RX ”
function for receiving dynamic RIP.
After the changes are completed, click “Apply” to save the network configuration
modification, or click “Cancel" to leave without making any change.
10.3.2 Static Routing Information Protocol
When there are more than one router and IP subnets, the routing mode for the device
should be configured as static routing. Static routing enables different network nodes to
seek necessary paths automatically. It also enables different network nodes to access each
other. Click the button “ Show Routing Table ” (as in the figure) to display the current
routing list.