QMS Magicolor, User Manual

Page: 305 / 446

DISK OPERATIONS
INSTALL OPTION
4. Press the Select key to enter the Install Option submenu. Press
the Next key until the hard disk destination of the optional font
or emulation displays in the message window.
5. Press Select to enter the destination. Then, press the Next key
until the source of the optional font or emulation displays in
the message window.
6. When you are prompted, insert the font or emulation card into
a slot on the front of the printer.
7. Press the Select key to enter the source. The printer copies the
contents of the card to the hard disk.
8. When the copying process is complete, press the Menu key to
exit the menu.
9. To remove the card, use the following procedure:
a. If you are removing an LN03 Plus or a ProCollection font card,
turn off the printer. Otherwise, make sure the printer is off line
(use the Online/Offline key to turn off the LED).
b. Pull the card out gently.
c. Turn on the printer, if it’s off, and put it back on line.
d. If you have installed CCITT emulation, before you send any
print jobs, use the printer configuration menu to increase the
amount of printer memory dedicated to non-PostScript
Emulations by 50 KB. Use the Administration/Memory/K Mem
Emulation submenu to do this. See chapter 4, “Printer
Configuration,” for information on using the configuration
menu.
NOTE: To use these fonts or emulations from an application,
make sure the printer driver installed supports them. If
not, contact your application manufacturer for a driver
that supports them.
Chapter 8
P r i n t e r O p t i o n s 8 - 4 7