0&
$&
&)
This feature can collate the media in the correct order and delivers it face-down.
The HCOS supports three modes for face-down media delivery: simple stacking,
job offset, and stapling.
Job offset
This feature offsets each job by sliding it to one side or the other. This allows for
easier separation of your collated output.
Stapling
This feature automatically produces stapled sets of output—up to 50 sheets per
set—for immediate distribution.
-
You can choose the output bin from the configuration menu or from your QMS 3260/
4032 printer driver. Use your driver to select the default setting for your print jobs or on
a job-by-job basis. The configuration menu option allows you to select options from
the printer control panel.
2++
This menu option allows you to select chaining for the output bins. When your print
jobs exceed the capacity of one output bin the job is continued on the next bin and
then the final bin until all are full (2000 sheets).
When all three bins are full the printer displays
X
OUTPUT BIN FULL
where
X
is the name of the selected output bin. The default names for the three bins
are Top-Stack, Center-Stack, and Bottom-Stack. Of course you have the option of
changing the names of any or all of the output bins.
Menu
Operator Control/Output Finishing/Chain Outputbins
Choices
On—Switch to the next outputbin with the same size and type of paper when
the default outputbin is full.
Off—Don’t chain outputbins
Default
Off
Summary of Contents for 3260
