+&#
#
4
Make sure you’ve loaded the media printing-side up. Many manufacturers place an
arrow on the end of the wrapper to indicate the printing side. If you can’t determine
which side of the media to print on, remove the media from the tray, rotate the stack
a half-turn, turn the stack over, and then place it back in the tray.
/##
Understanding the printer’s media path will help you locate media jams. The media path
is different for the different printer options. Refer to the following illustrations to view the
path depending on the options installed.
/
Media is picked up or fed (1) from
one of two input trays or the multipur-
pose tray. It is then transported to the
imaging area (2) where toner is
applied. Then it continues to the
fuser (3) where the toner is melted
into the surface of the media. The
media exits (4) the printer and is
stacked in the face-down bin.
1
1
1
2
3
4
Summary of Contents for 3260
