QLS 2000/3000 Series Digital Color Printers
Printer Setup
15
3. Open the drive roller by flipping the drive roller pressure cam lever open.
Figure 10, Drive Roll Cam Open
Figure 11, Drive Roll Cam Closed
4. Remove the media retainer from the media unwind mandrel.
5. Install a roll of media on the mandrel. Ensure that the roll is fully seated on
the mandrel and reinstall the retainer to secure it.
6. Thread the media around the media guide roller and through the media
travel sensor housing.
7. On QLS 2001 models, thread media under the media index roller. On all
other models thread media over the media index roller.
8. On models with standard print stations, thread the media over the platen
rollers and under the guide rollers (if present). On models with inverted
print stations, thread the media beneath the platen roller.
9. After threading the media over the platen roller on the last print station,
thread the media over the drive roller and out of the printer.
10. Slide the media against the plastic guide block on the vertical plate. Be sure
not to buckle the carrier against this block.
11. Close the printheads and the drive roller.