Qeedji SMH300, User Manual

Page: 30 / 80

30
b) Pair all the required SLATEs
To pair the required SLATEs to this SMH300, you have to select them, identified by their PSN in the
SLATEs detected
left table, and drop them into the
SLATEs paired to this device
right table.
In the
SLATEs paired to this device
right table, these values can be shown for each SLATE:
a check column: allows to select one or several SLATEs. Selecting a SLATE allows to access to further menus for these SLATEs.
#
:
Index
from 1 to 10,
PSN
: SLATE Product Serial Number,
Hostname
: name of the SLATE in the WPAN network,
RSSI
: received Signal Strength Indication (in dbm),
Quality
:
Quality of connection
:
Green
: the connection quality is very good and warranty the content update or the APPLI.CFG configuration file update within the 15
minutes interval,
Orange
: the connection quality is not perfect. The download error rate has reached a threshold that can affect the file download success
rate meaning that in some case the APPLI.CFG file or the content may not be updated for sure within the 15 minutes interval,
Red
: the connection quality is bad. The download error rate has reached a threshold that affect seriously the file download success rate
meaning that the APPLI.CFG configuration or the content will be not updated within the 15 minutes interval. The SLATE can not be used in
this condition. It is required to install the SLATE at another location,
Grey
: not yet determined (value shown in the tooltip).
Last wake-up on
³: mm/ dd/ yyyy, hh.mm.ss AM/ PM (value shown in the tooltip), last connection date & time of the SLATE to the SMH300.
Last synchronization on
: mm/ dd/ yyyy, hh.mm.ss AM/ PM (value shown in the tooltip), date & time of the last successful file downloading.
Auth.
:
PIN code
: a pairing
PIN code
is required,
None
: no pairing
PIN code
is required.
State
:
 Unpaired
: the SLATE having this PSN is not paired,
  Pairing in progress
: the SMH300 device is waiting the next SLATE wake up so that it takes the new APPLI.CFG configuration file.
 Paired
: the SLATE having this PSN is paired to this SMH300 device.
Mode
:
 Test Card
: the
Test Card
is displayed,
 Play
: the SLATE is configured to updated its
HUB.PPK
content.
☛ In case file download error, two automatical file download attempts are automatically done within the 15 minutes.
³ The
Last wake-up on
date value must be roughly the same for all the paired SLATE (modulo the heartbeat). In case the
Last wake-up on
date value
seems to be not correct, check the SLATE battery status in
WPAN Devices
menu of the
Information
pane.
In the
SLATEs paired to this device
right table, move up or move down the SLATEs so that they match the
Index
you have defined in the paragraph
above Prepare SLATE pairing configuration .
☛ By default, after a new SLATE dropping, the SLATE configuration leads to
Test card
activated and no pairing
PIN code
required.
Select one or several SLATEs in the
SLATEs detected
left table.
Then drop them into the
SLATEs paired to this device
right table using the right arrow button
 1
.
☛ If you try to pair a SLATE already used in a previous installation, and which was already been paired with a pairing
PIN code
, at the device
dropping, you are invited to enter the appropriate pairing
PIN C ode
(4 alphanumeric digits).