30 |
Fixing Slide Rail to Conveyor Beam with Screws
— Conveyor Chains |
Flextrac Series
Fixing Slide Rail to Conveyor Beam with Screws
CONVEYOR CHAINS
The beginning of each slide rail section must be fixed to the beam, since the
chain will cause the slide rail to be pushed forward. Slide rail which moves into
a wheel bend or a drive unit can block the chain completely.
There are two different methods for fixing slide rail to the conveyor beam:
• Using rivets (MA RR 3), this is applicable for MS2 and MM3
series only (see previous pages for instructions).
• Using screws (MA RS 6.5), this is applicable for ML2 and MX2 series only
Countersink holes on
slide rail.
2
Drill through holes on
slide rail.
1
Complete fitting slide rail.
5
Check that the screw does
not protrude over the
surface of the slide rail. Check both
top and bottom surface of slide rail
for protruding metal.
4
Apply screws into the
holes.
3
CARET-LEFT
