QC Conveyors FLEXTRAC Series, Manual

Page: 2 / 32

2 | Installation Site Preparation — Introduction to Installation | Flextrac Series
Installation Site Preparation INTRODUCTION TO INSTALLATION
CARET-LEFT
The purpose of this manual is to help the end user to assemble a Flextrac Series conveyor system. Every chapter includes detailed
instructions and photos showing how to assemble each component. Most photos in this manual include parts from MM3 conveyor
system, but all instructions are applicable to MS2, ML2, and MX2 conveyor system unless otherwise specified or noted.
Assembly Planning
Œ
Fully understand the assembly drawing.
Œ
Ensure the necessary tools are available.
Œ
Ensure all the parts and materials included on parts list are available.
Œ
Ensure necessary space for conveyor installation is available.
Œ
Ensure the floor is even so the feet can be properly attached to the floor.
Assembly Checklist
Œ
Cut all beams to desired length.
Œ
Connect all feet and structural beams.
Œ
Mount conveyor beam support brackets.
Œ
Mount slide rail onto the conveyor beam.
Œ
Assemble conveyor beams and mount them onto the support structure.
Œ
Mount drive and idler unit at the end of the conveyor.
Œ
Check for obstruction of the conveyor with a short piece of chain.
Œ
Assemble and mount necessary chain onto the conveyor.
Œ
Mount guide rail and other accessories onto the conveyor.
Œ
Read the final preparations at the end of this manual.