qcconveyors.com
| Plastic Belt Installation —
Mounting Drive Units
| 17
Mounting Drive Units
Mounting Idler Ends
PLASTIC BELT INSTALLATION
Sticky-note
CARET-LEFT
CARET-LEFT
Note: Drive units should be mounted with a support leg as shown below.
Loosen set screws
included in drive unit
connecting strips. Insert the
connecting strips into the T-slots
of the beam you want to attach
to the drive unit. Make sure that
the set screws do not prevent the
connecting strips from sliding into
place.
1
Insert the idler unit
connecting strips into the
T-slot of the beam end.
1
Tighten the set screws
using an Allen wrench.
2
Secure the idler end to
the beam using an Allen
wrench to tighten the set screws.
2
This section shows the method to mount drive units to the frame structure. All
drives come with connecting strips. Attach them to the conveyor beam using an
Allen wrench and the set screws that are included.
Remember!
Conveyor belt should always be pulled, not pushed, by the drive unit.
This section shows the method to mount idler ends to the frame structure. All
idlers come with connecting strips. Attach them to the conveyor beam using an
Allen wrench and the set screws that are included.
