![background image](http://html1.mh-extra.com/html/pylo-health/py-802-lte/py-802-lte_user-manual_1632200007.webp)
1. Plug the connector into the ‘Cuff Port’ as labeled on
the device.
2. Expose your upper arm by removing or adjusting
clothing and jewelry. Make sure blood flow is not
constricted by a rolled up sleeve.
3. Open the cuff and loosen fully.
4. Orient the cuff so that the tube exits towards the hand.
5. Place your arm through the cuff loop, with your palm
facing up.
6. Position the cuff’s edge about an inch (2–3 cm) above
the elbow.
7. Align the Ф marker (located to the right of the tube
exit) with the center of your arm.
8. Tighten the cuff evenly around your arm by pulling
on the end—make sure the Ф marker stays aligned
with the center of your arm.
9. Wrap the end of the cuff over your arm to secure it in
place. Don’t make it too tight—allow a finger to fit
between the cuff and your arm.
10. If possible, relax and rest for at least 5 minutes
before taking a measurement.
11. Lay your arm on a table with your palm facing up.
The cuff should be at the same height as your heart.
Sit up straight and rest your feet flat on the ground.
Make sure the tube is not kinked or pinched.
When you insert or replace batteries into the device, the symbol
and will be shown on the LCD. This indicates that
the device is searching and pairing with a mobile network. You
can long press “ START/STOP ” button to end pairing and use
the device. If you manually cancel pairing, the device may take
longer to send a measurement after use..
When pairing is successful,
the symbol is shown
on the display. You can then
utilize the device as normal
by pressing “START”.
2~3cm
BEFORE YOU START
MEASUREMENT
11
10
Tip:
Tie the Cuff