Galaxy
®
GT6 Display Series Installation
Quick Guide
DD3894912
Rev 01
12 October 2021
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Page 1 of 2
Mount Display
1.
Lift the display into position on the support
structure.
2.
Weld or use
1
/
2
" hardened bolts to secure all
clip angles to support structure.
3.
Remove crane support from the display.
4.
Remove all eyebolts if desired. Seal all of the
remaining holes with silicone approved for use
on aluminum.
5.
Make sure display structure or shrouding does
not block display ventilation.
Connect Power
Refer to the label on back of the display or to the
display riser drawing for power requirements.
Displays require either 120 VAC (2 wire + ground)
or 120/240 (3 wire + ground).
1.
Wire Line 1, Line 2, neutral,
and ground wires according
the shop drawing.
2.
Connect grounding electrode
to ground lug on each display
face.
3.
Test the display ground to
ensure it meets the provisions
of all applicable local and
national codes.
Communications Installation
1.
Connect the signal cables to the proper Quick-
Connect Jacks on the back of the display.
Note:
Remove protective cap from cables.
120/240 VAC Termination
(Box with Cover Removed)
Wiring from power termination
panel inside display
Line 1 – Brown
Line 2 – Brown
Neutral – Blue
Ground –
Green/Yellow
For future display maintenance:
Turn the
1
/
8
" hex head wrench counter-clockwise to remove modules from the
display face.
Turn the
1
/
8
" hex head wrench clockwise to secure modules to the display face.
Refer to the Galaxy
®
GT6 Installation and Operation Manual (DD3894917) for more information.
