Pulsar ULTRA 5, Instruction Manual, Page: 216 / 258

Page 208
Option Description
When Ultra Wizard = 2 Pump/Differential
4 = Avg. Level mA output is relative to the average level of
two points of measurement. P100 = 4
5 = Differential
mA output is relative to the differential
between two points of measurement P100 = 5
When Ultra Wizard = 3 Flow
4 = OCM Head mA output is relative to OCM head .
5 = OCM Flow mA output is relative to OCM flow .
6 = Average Flow mA output is relative to average flow
Setpoint
By default, the mA Output will represent the empty ( 0 or 4mA dependant
on ( P830 ) mA Range ) and 100% of the operational span ( 20mA ), but you
may wish to have the output represent a section of the operational span. For
example, the application has an operational span of 6 metres but
output is to
represent empty ( 0 or 4mA dependant on ( P830 ) mA Range ) to a level of
5 metres ( 20mA) . If so P834 (Low Level) should be set to 0.00 metres and
P835 (High Level) should be set to 5 metres.
P834 mA Low Level
This parameter sets the level, distance or space, depending on the selected
mA Out Mode ( P831 ) at which the low mA output will occur ( 0 or 4mA
dependant on ( P830 ) mA Range )
Default = 0.000m
P835 mA High Level
This parameter sets the level, distance or space, depending on the selected
mA Out Mode ( P831 ) at which the high mA output will occur ( 20mA ).
Default = 6.000m
Limits
P836 mA Low Limit
This parameter sets the lowest level that the mA output will drop to, the
default is 0mA, but you can override this if the device you connect to cannot
for example accept less than 2mA, yet you want to use the 0-20mA range.
Default = 0.00mA