Pulsar TC-10B, User Manual

Page: 180 / 190

Option 1: Local Connection
Plug the handset into the Voice Adapter
Module at the front panel "HANDSET"
jack.
Option 2: Remote Connection
Connect the handset through a remote jack to
the TC-10B rear panel (see Figure 17-6).
Option 3: Combination Remote Hookswitch -
Telephone Jack Connection
Remotely connect a telephone jack and a
hookswitch assembly to the TC-10B rear
panel (see Figure 17-6).
Option 1: Using the Local Handset
Configuration
To configure your system for this option, set the
DIP switch (SW1) to the normal, or default,
settings as shown in Table 17-3.
To initiate signaling with this option:
1. Plug the handset into the Voice Adapter
Module at the front panel "HANDSET"
jack.
2. Press the push-to-talk switch on the
handset.
This rings the other end of the system.
To answer a ring (at the receiving end) with this
option, plug a handset into the Voice Adapter
Module at the front panel "HANDSET" jack. This
stops the ringing by turning off the internal alarm
circuit. (The internal alarm circuit includes an
audible beeping alarm, an alarm LED, and a relay
contact output.)
To configure for external ringing, disable the
internal beeper by setting SW1-4 to the UP
(OPEN) position (see "DIP Switch Settings" later
in this chapter). Then connect an external alarm,
as shown in Figure 17-6.
Option 2: Using the Remote Handset
Configuration
To configure your system for this option:
1. Disable the internal beeper by setting SW1-
4 to the UP (OPEN) position.
2. Connect a remote handset jack and an
external alarm circuit in series with the
TB5 terminal block on the TC-10B rear
panel. Use the wiring diagram in Figure 17-
6 as a guide.
To initiate signaling with this option:
1. Plug the handset into the remote handset
jack.
2. Press the push-to-talk switch on the
handset.
This rings the other end of the system.
To answer a ring (at the receiving end) with this
option, plug the handset into the remote handset
jack. The remote jack stops the ringing by inter-
rupting the external alarm circuit.
Page 17–2 October 2003
TC–10B System Manual
Technologies, Inc.
NOTE
Whenever you are using a remote handset, you
should disable the internal beeper and replace it
with an external alarm
.