Pulsar TC-10B, User Manual

Page: 165 / 190

As with most settings, you can only change this
one if the DIP switch is set to "CUSTOM".
Example:
set period 4–Executes periodic auto
checkback tests every four hours.
Set Loopback Duration
Minimum abbreviation: set loop ss
Loopback duration specifies in seconds how long
a module keeps the carrier on during a loopback
test. You can set this time from four (4) to 60
seconds. You start loopback tests either with the
do loopback command (see "Do Loopback Test")
or with the front and rear panel loopback switches.
As with most settings, you can only change this
one if the DIP switch is set to "CUSTOM".
Examples:
set loopback duration 5–Sets the local
module's duration to five (5) seconds.
set loop 60 > 2–Sets remote #2's loopback
duration to 60 seconds.
Set Carrier Recovery Period
Minimum abbreviation: set carrier mm
You can set how often checkback tests are run
during the Carrier Recovery window to retest the
carrier at an expedited rate once it has failed. If the
checkback is successful for three consecutive
tests, the system resets or “recovers”. If the
checkback is not successful during the recovery
window, the Delayed Alarm is set.
Example:
set carrier 15-Sets the local checkback to
expedite the checkback interval to every 15
min.
set carrier 20 > 1-Sets the checkback with
address 1 to expedite the checkback
interval to every 20 min.
Set Carrier Recovery Window
Minimum abbreviation: set wind hh
You can set the recovery window from 1 to 24
hours. This is the timeframe in which the
checkback must receive 3 consecutive successful
checkbacks. If this fails, the Delayed Alarm is set.
Example:
set wind 3-Sets the local checkback
recovery window to 3 hours.
set wind 1 > 3-Sets the recovery window
of remote checkback, with address 3, to 1
hour.
Set Automatic Clock Synchronization
Minimum abbreviation: set sync on | off
When enabled, the master module synchronizes
the clocks of all remotes in the network starting at
12:30 a.m.
As with most settings, you can only change this
one if the DIP switch is set to "CUSTOM".
Example:
set sync on–Enables automatic clock
synchronization by the master.
Set Clock
Minimum abbreviation: set cloc hh:{mm:{ss}}
Updates the checkback module's clock. With this
command, you can set the clock to the nearest
second. Remember to enter times in 24-hour
format.
Unlike most settings, you can set the clock no
matter which setting the DIP switch is on.
Examples:
set clock 1:02:56–Sets the local module's
clock to 1:02:56 a.m.
set cloc 13:00:00 > 1–Sets remote #1's clock
to 1:00 p.m.
set cloc 3–Sets the local module's clock to
3:00:00 a.m.
October 2003 Page 16–31
Chapter 16. Universal Checkback Module
16