Pulsar TC-10B, User Manual

Page: 45 / 190

3.1 Unpacking
If the TC–10B is shipped unmounted, it is in
special cartons that are designed to protect the
equipment against damage.
3.2 Storage
If you are setting the equipment aside before use,
be sure to store it in its special cartons (in a
moisture-free area) away from dust and other
foreign matter.
3.3 Installation Location
Install the TC–10B in an area which is free from:
• Temperature exceeding environmental
limits (See “Environmental Requirements”
in Chapter 1)
• Corrosive fumes
• Dust
• Vibration
3.4 Assembly
You can assemble the TC–10B for use in any of
the following configurations:
• Mounted in a fixed-rack cabinet.
• Mounted in a swing-rack cabinet
• Mounted on an open rack.
or in your own, customer-specified configuration.
Refer to Figure 3-3 for mounting dimensions.
3.5 TC–10B Rear Panel
Connectors
The following connectors are accessible from the
Rear Panel (See Figure 3-1):
• Terminal Blocks
• Cable Jacks
• Jumpers
• Input/Output Pins
• RS-232 DB9 female (for future use)
Copyright © 2003 Pulsar Technologies, Inc.
Chapter 3. Installation
3
!
CAUTION
UNPACK EACH PIECE OF EQUIPMENT CARE-
FULLY SO THAT NO PARTS ARE LOST.
INSPECT THE CONDITION OF THE TC-10B AS IT
IS REMOVED FROM ITS CARTONS. ANY
DAMAGE TO THE TC-10B MUST BE REPORTED
TO THE CARRIER. DAMAGES ARE THE
RESPONSIBILITY OF THE CARRIER AND ALL
DAMAGE CLAIMS ARE MADE GOOD BY THE
CARRIER. SEND A COPY OF ANY CLAIM TO
PULSAR TECHNOLOGIES, INC.
!
CAUTION
IF YOU ARE USING THE TC-10B WITH A SWING-
RACK CABINET, MAKE SURE THAT THE
CABINET IS FIRMLY FASTENED BEFORE
OPENING THE RACK (TO PREVENT TIPPING).