Chapter 7: Expansion Modules
Installing The PCMCIA Module
126
Psion Teklogix WORKABOUT PRO Hand-Held Computer User Manual
Figure 7.4 PCMCIA Module
•
Remove the batteries. If your unit is using AC power, disconnect it.
•
Remove the end-cap and back plate.
•
Slide the SW1401 switch to the left to shut off internal battery power.
•
Remove the two screws at the top of the metal frame.
•
Align the connector on the PCMCIA module with the expansion connector
on the hand-held, and gently snap the PCMCIA module connector into the
expansion connector.
•
Using six screws, fasten the module into place on the main logic board.
Remember to replace the two metal frame screws to secure the module and
frame in place.
Important:
Once the PCMCIA module is installed in the unit, you do not
need to remove the back plate to insert a PCMCIA PC card. Just
remove the end-cap and slide the card into the unit.