Psion Teklogix WORKABOUT PRO Hand-Held Computer User Manual
125
Chapter 7: Expansion Modules
Shutting Off Power
7.1.3 Shutting Off Power
Before installing a module or card in the WORKABOUT PRO, all power sources
must be turned off.
•
Remove the batteries. If your unit is using AC power, disconnect it.
•
Remove the stylus from the top of the unit.
•
Remove the end-cap, and slide the SW1401 switch to the left to shut off
internal battery power.
Figure 7.3 SW1401 Power Switch
7.1.4 Installing The PCMCIA Module
Important:
The WORKABOUT PRO does not support hot swapping. All
power sources must be turned off before inserting any card or
module in the unit.
To insert a PCMCIA PC card in your WORKABOUT, you will need to install a
PCMCIA module equipped with a 100-pin connector. This module snaps onto the
expansion connector on your WORKABOUT PRO.
SW1401 Power Switch
