Installation
PowerPlay IPC-8000 and IPC-9000
4826 Sterling Drive, Boulder CO 80301
15-052-01-1-DOM-B
PH: 720.406.8946 [email protected] www.psaudio.com
©2010 PS Audio International Inc. All rights reserved.
Connect the Load
Connect each of the devices to be powered by the PowerPlay. Be sure to make a list of each device and the
power zone in which they are located.
Connect Phone
To protect any device which connects to the telephone line connect the telephone cable from the wall outlet to
the “TELEPHONE IN” jack on the PowerPlay. Then connect the telephone cable to the “TELEPHONE OUT” jack
on the PowerPlay and to the device.
To use the
Phone Control
features of the IPC-9000 connect a dedicated phone line or extension using a
standard telephone cable into the “PHONE” jack.
Connect Satellite / Cable / Antenna
To protect satellite, cable, and/or antenna devices connect the coaxial cable from the wall to the coaxial “IN”
jack on the PowerPlay. Then connect the coaxial cable to the “OUT” jack of the vertically grouped input and
output pair on the PowerPlay and then to the device.
Connect to the Internet
To protect any device which connects to the internet connect the Ethernet cable from the wall outlet to the
“DATA IN” jack on the PowerPlay. Then connect the Ethernet cable to the “DATA OUT” jack on the PowerPlay
and to the device.
To enable web based control, connect an Ethernet cable from a live connection to the “ETHERNET” jack on the
PowerPlay.
Self Test and Power Up
When the PowerPlay is plugged into the wall or when it recovers from a power failure it will run a short self test.
During the self test the device will illuminate the display window and display model and firmware information
Upon completion of the self test, PowerPlay may be turned on by pressing the PS Audio blue logo button in the
center of the front panel.
