Proyecson PAA29+, Instruction Manual

Page: 20 / 54

INSTALLATION MANUAL: PAA29+ V 1.4 (07/2011) 20
7. CONFIGURATION OF THE PAA29+ ETHERNET PORT
Before connecting the PAA29+ to the server over Ethernet, set up the
PAA29+ port in order to be in the same sub-network as the server.
There are several ways to do it.
7.1 OVER A TCP/IP CONNEXION
In order to connect with the PAA29+ Ethernet over a TCP/IP connection, it is
necessary to know the IP address of the PAA29+. The device is delivered
with the IP 192.168.1.180; we strongly recommend to annotate the new IP
in case of changing it in order to be able to set up the port in the future. If
the device doesn’t have the factory IP, it is possible to connect with it using
the RS232 port to verify or modify the IP.
To configure the Paa29+ over Ethernet follow this instructions:
1. Connect the PAA29+ to an Ethernet switch as well as the PC that will
be used to configure it.
2. Both devices have to be connected to the same sub-network, therefore
if the PAA29+ still has the factory configuration, the PC should be able
to access the IP address 192.168.1.180.
3. Once both devices are connected and the PC is configured, it is
possible to do a “ping” to check if the PAA29+ is accessible from the
PC.
4. With the connection operative, open a browser (firefox, Internet
Explorer, opera, etc) and insert in the address bar the PAA29+ IP
address. If everything goes as planned, the browser will ask the login
name and a password (
Figure 7.1A ), leave the login name and the
password blank and accept (Press enter).