2-8
Chapter Two
CONTROL PANEL INDICATORS
These indicators provide important status information about your projector.
Source
Setup
Menu
Over-Temperature
Replace Lamp
Figure 2-11 Lightbook projector’s control panel indicators
INDICATOR
FUNCTION
Glows red to warn of an over-temperature condition.
Flashes quickly if the projector is not completely open.
Flashes slowly if the spare lamp burns out.
Glows red when the active lamp burns out.
Flashes quickly if the projector is not completely open.
Over-Temperature
The
indicator glows red if the projector overheats. A thermostat
automatically turns off the power to the lamp until the projector cools.
If an over-temperature condition occurs, perform the following checks while
you allow the projector to cool:
• Verify that the room temperature is below 86
°
F (30
°
C).
• Check the intake and exhaust vents. Clear any obstruction to the air flow.
• Make sure that the fans are working. If the projector has reached an
over-temperature condition and the fans are working, you should feel a
strong flow of hot air from the left rear vent. If the fans are not working,
the projector needs service.
NOTE: If you are using the projector at a high altitude location or in a warm
room, you may want to switch to High Altitude mode (Preferences menu) to
run the fans at a higher speed (see page 2-23).