MP.11 and MP.11a Installation and Management
Chapter 2. Installation
32
Chapter 4. Basic Management
This chapter describes the initial setup of the MP.11/a, which lets you configure and monitor the basic features of
the MP.11/a. In most cases, configuring these basic features is sufficient.
A full overview of the Web Interface is provided in “Chapter 5. Web Interface”
on page 43
; “Glossary” on page
137
provides a brief explanation of the terms used.
For CLI commands you can use for basic management, see “Command Line Interface“ on page 94.
The following topics are discussed in this chapter:
•
Rebooting and Resetting on page 33
•
General Settings on page 34
•
Monitoring Settings on page 39
•
Security Settings on page 41
•
Upgrading the MP.11/a on page 42
To use the Web Interface for configuration and management, you must access the MP.11/a. With ScanTool you
can determine the unit’s current IP address. Then enter http://<ip address> in your Web browser. See “Chapter
3. Management Overview” on page 23
for details.
The Web Interface consists of Web page buttons and tabs. A tab can also contain sub-tabs. The following figure
shows the convention used to guide you to the correct tab or sub-tab.
The Web Interface also provides online help, which is stored on your computer (see “Installing Documentation
and Software” on page 21
for details).
