MP.11 and MP.11/a Quick Install Guide
Chapter 5. Web Interface
45
CONFIGURE
Use the
Configure
section to change the settings of the MP.11/a. There are 10 tabs in this section.
Note
: The Intra-Cell Blocking tab is available for Base Stations in Bridge mode only. The NAT tab is available for
SUs in Routing mode only.
1. System
below
2. Network on page 47
3. Interfaces on page 55
4. SNMP on page 60
5. RIP on page 61
6. Management on page 64
7. Security on page 67
8. Filtering on page 70
9. Intra-Cell Blocking on page 75
10. NAT (Network Address Translation) on page 79
1) System
The System configuration page lets you change the MP.11/a’s System Name, Location, and so on. These details
help you to distinguish the MP.11/a from other routers and let you know whom to contact in case you experience
problems.
Click the
Configure
button and the
System
tab; the following window is displayed.
In this window, you can view or change the basic system information.
Mode of Operation
sets the MP.11 as
bridge
(layer 2) or as
router
(layer 3).
