PRO-VISION
®
Video Systems
30
provisionusa.com
Digital HD Side Camera Installation
The Waterproof Night Vision Side Camera (Kit P/N: DVR-814, Camera
P/N: PC-1814) is designed to mount on the left or right side of a vehicle
and capture video along the side of the vehicle. This camera has a
horizontal coverage of a ~75° that provides exceptional capability to
capture street signs, license plates, and other details not normally
captured by wide angle cameras. This camera is most often used in
applications where it is necessary to capture license plates of other
vehicles passing the camera. The camera also has night vision and a
light sensor to automatically enable the night vision when necessary.
With its waterproof IP-67 housing, this camera can be mounted to the
exterior of the vehicle and handle all weather conditions.
Mounting Location:
This camera is often used on school buses mounted on the driver’s side near
the stop arm to capture license plates of vehicles passing the bus.
The camera can only be mounted to a vertical surface, it can be mounted facing
forward or rearward and can adjust up to 90° outward in either position. The
camera mounting screw holes are slotted to allow the camera to be aimed
upward or downward after mounting.
Installation:
1. Gently spread the two sides of the bracket apart and slide the
camera in place with the pivot pins on each side of the bracket
aligned to the center hole on each side of the camera as show in
the image to the right.
2. Locate the desired mounting location of the camera. It is
recommended to power on the DVR unit and temporarily connect
the camera to it and observe that the view in the desired mounting
location is satisfactory before proceeding to the next step.
3. When the desired mounting location is found, mark or measure the two (2)
mounting screw hole locations in the bracket (Shown in
ORANGE
at right). If
necessary, remove the camera from the bracket.
4. If the cable will be routed through the vehicle body, typically it is routed through
a 5/8” holed drilled directly in the center of the vehicle body behind the bracket
(Shown in
RED
color above). Mark and drill this hole if needed. Remove any
burrs from the hole to prevent damage to the cable.
5. Install the camera bracket to the marked locations from step 3
(Shown in
ORANGE
above). Ensure the bracket is oriented for
properly aim as shown in the image at right, if needed flip the
bracket 180°.
6. Install the camera into the bracket by spreading the bracket apart
slightly and aligning the center holes on each side of the camera
with the pivot pins on the bracket.
Pivot Pin
Direction of Camera Aim
Vertical Mount Only
Summary of Contents for DVR-906M
Page 1: ...6 11 2020...
