PRO-VISION
®
Video Systems
34
provisionusa.com
Digital HD Super Wide Angle Camera Installation
The Super Wide Angle Camera (Kit P/N: DVR-818, Camera P/N: PC-1818)
is designed to provide superior coverage inside the vehicle. The camera is
very similar to another camera model (DVR-813) visually, but this camera
has a wider field-of-
view and two infrared (IR) LED’s to the left and right of
the camera lens. This camera has a super wide 175° horizontal field-of-view
that allows it to cover door-to-door even when it is not mounted centerline of
the vehicle. However, the best location for coverage is mounted centerline of
the vehicle.
The camera has a sensor to turn the IR LED’s on/off as required.
A microphone is built into the front of the camera. There is also a red LED on
the front of the camera that will flash to indicate the recording status.
Mounting Location:
The mounting location depends on vehicle type and desired coverage. Most often the camera is used for
additional coverage in the rear area of the vehicle for passengers or cargo. The camera is very small and
lightweight and can be mounted directly to a metal surface, plastic panel, or the vehicle headliner.
On most buses the camera is mounted directly above the wire panel running above the side windows of
the passenger area. Do not mount camera with any light source directly in the field of view as it will affect
the picture quality.
Standard Bracket Installation:
1. Slide the bracket over the top of the camera and loosely
attach two of the camera’s side attachment screws
through the round (not slotted) holes on each side.
2. Hold the camera in the desired mounting location.
Ensure that the remaining two (2) camera side
attachment screws will line up through the slots. If the
holes do not line up, then the bracket will need to rotated
180 degrees to provide proper adjustment for installation.
3. It is recommended to power on the DVR unit and temporarily connect the camera to it and
observe that the view in the desired mounting location is satisfactory before permanently
attaching the camera and routing the cable(s).
4. When the desired mounting location is found, mark or measure the two (2) mounting screw hole
locations in the bracket (Shown in
ORANGE
at right)
5. Remove the side attachment screws and then put the
bracket in its mounting location using the marks or
measurements made in the previous step.
6. Use the included self-tapping mounting screws to attach the bracket to the mounting location. If
there is not adequate strength in the mounting surface or adequate space behind it then bolts,
nuts, and washers should be used for mounting.
Summary of Contents for DVR-906M
Page 1: ...6 11 2020...
