Provision DVR-906M, System Manual

Page: 29 / 73

PRO-VISION
®
Video Systems
27 provisionusa.com
Digital HD Dome Camera Installation
The Night Vision Dome Camera (Kit P/N: DVR-810, Camera P/N: PC-1810)
is a versatile camera for use inside a vehicle. It is not waterproof and cannot
be mounted outside the vehicle. It has a built-in microphone for audio
recording as well as built-in night vision LED
’s with an automatic sensor for
capturing video in low-light conditions. The camera is used most often inside
large transit vehicles such as buses and trains, but it also works well in the
cargo area of box trucks and vans.
Mounting Location:
This camera is very flexible for mounting purposes; it can be mounted in
almost any direction and the camera ball adjusted back to a level image.
The ball and socket dome design allows 360° rotation around the base,
180° adjustment perpendicular to the base, and 360° rotation to level the
image. The camera typically is installed with the cable going through a
panel directly underneath the mounting location to hide the cable, but it can
also be installed where the cable exits the side of the base if there is no
room to route the cable behind the camera’s mounting location.
Installation:
1. Disassemble the camera by loosening the three (3) Phillips head
screws on the camera housing base. Then separate the bottom
base from the camera ball and mounting rings.
2. Find the desired camera mounting location and hold the camera
base up in position. Mark the three (3) mounting holes using a
marker (Shown in
ORANGE above right). The camera holes are
slotted, only mark the center of the large hole in the slot in each of
the three positions.
3. If the camera cable will route through the mounting surface, mark
an additional hole at the center of the base (Shown in RED above
right)
4.
If applicable, drill out the marked center hole to 5/8” using a drill bit
or step drill bit. Clean up any sharp edges to prevent damage to
the cable.
5. Align the camera base over the marked screw holes and then using
a cordless drill with Phillips bit, install the three (3) self-tapping
mounting screws.
6. If the camera cable will exit the side of the camera in front of the
mounting surface, you must loosen the three (3) screws slightly to
feed the camera connector between the camera base and the
mounting surface. Then align the camera cable into one of the
notches in the camera base and carefully tighten the mounting
screws of the base.