Provision DVR-906M, System Manual

Page: 38 / 73

PRO-VISION
®
Video Systems
36 provisionusa.com
2. Ensure that there is sufficient clearance behind the panel to allow the camera to be mounted;
1.25
” of clearance is required.
3. Determine the orientation of the mounting bracket by the desired mounting angle. Observe the
image above and the desired mounting angle and align the holes as show in RED color with the
camera’s mounting holes
4. Install the four (4) side mounting screws in the sides of the cameras according to the holes in
RED color above. For mounting in the -20° angle configuration, the rear two (2) screws will be
threaded into the bracket only to prevent the camera from rotating.
5. Hold the camera back in the desired mounting location and observe the view on the DVR, but this
time hold the camera with the bracket face parallel to the mounting surface, this will simulate the
camera’s final mounting view. If the mounting angle needs to be adjusted, repeat steps 3-4 at
this time.
6. Measure, mark, and drill the two main holes for
the camera to recess into, the holes are 1.25
“
diameter and 2
“ apart as shown in
RED color to
the right.
7. Use a shears or grinding tool to cut the remaining
material between the two holes out as shown in
AMBER color to the right.
8. Insert the camera and bracket assembly through
the newly cut mounting hole with the cable first.
After the camera is in the hole ensure that the
bracket sits flush with the mounting surface. If any of the mounting surface was deformed during
the drilling or cutting use a file or deburring tool to remove the deformation so the bracket sits
flush.
9. Use the four (4) included self-tapping mounting screws to attach the bracket to the mounting
location in the mounting holes shown above in GREEN color. If there is not adequate strength in
the mounting surface or adequate space behind it then bolts, nuts, and washers should be used
for mounting.
10. Power on the DVR unit and connect to the Wi-Fi to view the live camera image to ensure the view
is as desired. Remove the screws from the bracket and then repeat steps 3, 4, and 9 until the
best of the five (5) available aim it is selected.
Clearance
1.25”
Hole Diameter
1.25”
2” Center to Center
+20° +10° 0° -10° -20°