Provision DVR-906M, System Manual

Page: 17 / 73

PRO-VISION
®
Video Systems
15 provisionusa.com
Analog HD Mini-Dome Camera Installation
The AHD Mini-Dome Camera (Kit P/N: DVR-921, Camera P/N: PC-1921) is
designed to be mounted inside a vehicle. The camera is used most often inside the
passenger seating areas inside buses and trains, but it also works well in the cargo
area of box trucks and vans. It has a built-in microphone for audio recording as well
as built-
in night vision LED’s with an automatic sensor for capturing video in low-
light conditions. Its small form factor and high adjustability allow this camera to be
mounted in a multitude of interior locations. The camera lens has a wide 170°
horizontal and 90° vertical coverage.
Mounting Location:
The ball and socket dome design allows 360° rotation around the base,
180° adjustment perpendicular to the base, and 360° rotation to level the
image. The camera typically is installed with the cable going through a
panel directly underneath the mounting location to hide the cable, but it
can also be installed where the cable exits the side of the base if there is
no room to route the cable behind the camera’s mounting location.
Installation:
1. Disassemble the camera by loosening the three (3) hex head set
screws located on the locking ring. Lift up on the locking cover
and remove it from the camera assembly. Remove the camera
ball and pull the cable through the mounting base.
2. Find the desired camera mounting location and hold the
mounting base up in position.
3. Mark the four (4) mounting holes using a marker or pencil.
4. If the cable is going to be routed through the center cable hole
and into a panel, mark the center cable hole as well.
5. If applicable, drill out the marked center hole using a 3/4
” drill bit.
Clean up any sharp edges to prevent damage to the cable.
6. If the camera cable will exit through the cable grove in the
mounting base instead of through the mounting surface, the
cable must be routed through the cable grove before attaching
the mounting the base to the mounting surface.
7. Align the camera base over the marked screw holes and then
using a drill with a Phillips bit, install the four (4) self-tapping
mounting screws.
8. Connect the camera connector to the cable running to the DVR
unit, if it is not yet installed, install the cable at this time and then
continue to step 9.
9. Hold the camera ball and feed any excess cable through the hole
or cable grove in the mounted base until the camera ball is
resting on the center of the mounting base.
360
°
360
°
180
°