ADJUSTING YOUR TRIGGER
The Trigger’s forward travel and over travel are fully
adjustable so that the user can fine-tune the trigger
to his/her exact preference. To adjust the trigger
you will need an .050” and 5/64’ Allen key. There is
one adjustment screw located on the right side of
the Ultralite frame behind the sticky grip, one
adjustment screw located in the top of the trigger,
and one adjustment screw behind the trigger.
The adjustment screw in the top of the trigger (1)
adjusts the forward travel of the trigger and
requires an .050” Allen key to adjust. Screwing it in
will shorten the length of the triggers pull. NOTE: If
this screw is adjusted too far, the switch will be held down at all times and the marker will not fire.
The adjustment screw on the right side of the frame (2) adjusts the over travel of the trigger and
requires a 5/64” Allen key to adjust. Screwing it in will shorten the length of the triggers pull.
NOTE: If this screw is adjusted too far, the trigger will not be allowed to travel far enough to
depress the switch and fire the marker.
The screw located behind the trigger (3) is used to change the tension of the trigger spring and
requires a 5/64” Allen key to adjust. To make the trigger pull stiffer; turn the Allen key clockwise
or in. To make the trigger pull lighter; turn the Allen key counterclockwise or out.
2
1
3
FIGURE 1
TRIGGER
ADJUSTMENT
• Be sure the trigger is not adjusted to the point where it is too sensitive and
may cause accidental discharge of the marker.
• Removing the trigger spring will cause premature wear on the microswitch,
resulting in failure.
REFLEX RAIL™ BOARD
SETTINGS AND FUNCTIONS
BATTERY
The 9V battery will last for about 40,000 shots. Please be
aware that there are substantial differences in performance
between different brands of batteries. Use of high quality
alkaline or lithium ion batteries is recommended for maximum
battery life. If you plan not to use your marker for a long period
of time (a month), it is recommended that you remove the
battery from the marker. When the battery voltage starts to go
too low, the marker will not fire with every trigger pull. For
tournament use, it is recommended to change the battery for
each tournament.
CHANGING THE BATTERY
The battery is housed on the right side of the grip frame. To
access the battery, remove the three screws holding the right side grip panel down.
Use a 3⁄32” Allen key. When inserting a new battery notice the + and - marks on the
board. The positive lead of the 9V battery goes to the left and the negative lead to
the right.
NOTE: If the marker will not function with the eye on, there is a good chance the
battery needs to be changed.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
12
13
2011-Reflex-RAIL-Manual.qx_2011-Reflex-RAIL-Manual 11/22/10 12:40 PM Page 15
