REFLEX RAIL
™
BOARD
SETTINGS AND FUNCTIONS
RAIL
™
BOARD
SETTINGS AND FUNCTIONS
TURNING THE REFLEX RAIL™ ON AND OFF
To turn on the REFLEX RAIL™, press and hold the power
button until the LED’s turn blue. The blue light indicates
board boot up. After the boot up sequence, the LED’s will
turn either RED (no ball) or GREEN (ball in breach, ready to
fire). To turn the REFLEX RAIL™ off, press and hold the
power button until the LED’s turn off.
NOTE: The REFLEX RAIL™ automatically switches off after
10 minutes of non-use.
FIRING THE REFLEX RAIL™
As soon as the marker is turned on and the LED’s turn from
blue to either red or green, the REFLEX RAIL™ is ready to
fire. If there is no ball and the LED’s are RED, you need to
hold the trigger for 1 second to force the REFLEX RAIL™ to
fire once. If there is a paintball inside the breech and the LED
is green, just press the trigger to fire the marker.
LED LIGHT INDICATOR
The REFLEX RAIL™ uses two super bright LED’s mounted on
the circuit board inside the grip frame. These two lights are
used to provide information to the user about the REFLEX
RAIL™. They will always show the same information and it
does not matter which LED you look at. One is mounted
behind the PROTO™ logo on the left side of the grip panel.
The other one can be seen by looking at the top left side of
the grip frame while holding the REFLEX RAIL™ in the position
you would while playing a game.
When you turn on the marker in normal operation mode with the power button, the light colors
mean the following:
Blue
-
Boot sequence
Red
-
Breech is clear, no ball detected inside the REFLEX RAIL™ (eye is on)
Green
-
Ball in breech, ready to fire (eye on)
Blinking
Red
-
Eye is turned off
Blinking
Green
-
Eye failure, eye is blocked or dirty (see REFLEX RAIL™ Eye, page 26)
Blinking
Blue
-
Indicates a low battery; battery should be changed as soon as possible
To turn off the eye feature press and hold the bottom button until the LED light starts blinking
Red indicating the eye feature is turned off.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
6
7
When servicing your marker:
• Make sure a barrel sock is fitted to the REFLEX RAIL™.
• Make sure your hopper is removed from the REFLEX RAIL™.
• Make sure there are no paintballs in the breech of the REFLEX RAIL™.
• Always remove the first stage regulator and relieve all residual gas
pressure from the REFLEX RAIL™ before disassembly.
• The REFLEX RAIL™ can hold a small residual charge of gas, typically 2
shots, with the first stage regulator removed. Always discharge the marker
in a safe direction to relieve this residual gas pressure.
NOTE: The eye is always activated when you turn the marker on.
2011-Reflex-RAIL-Manual.qx_2011-Reflex-RAIL-Manual 11/22/10 12:40 PM Page 9
