Configuration Commands
RLXIC-SG
♦
Intelligent Cellular
User Manual
RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
ProSoft Technology, Inc.
Page 111 of 136
May 29, 2009
11.3.8 PassThru
PassThru Mode is used to communicate directly to the RLXIC-SG internal
hardware.
Caution:
While the modem is in PassThru mode, ALEOS is disabled. If you need to connect to the
RLXIC-SG while it is in PassThru mode, you will need to do so with a terminal application. Not all
commands are available while the modem is in PassThru mode.
\APASSTHRU
Note:
This mode is not available through the remote AT telnet server. You will need to connect to
the RLXIC-SG with it connected directly to your computer.
Sets the modem operation to pass through mode. This mode will pass any
characters received on the port Ethernet directly to the internal hardware module
and output any characters from the internal hardware module out the port
Ethernet. This allows direct access/configuration of the hardware module. After
this mode is entered, the unit must be physically reset to return to normal
operation. This command is not available in AceManager.
Note:
It may take up to 30 seconds for the hardware module to respond after CONNECT is output.
*CSX1=n
PassThru Echo : Echo data to the host.
n=0
: Data will be passed to the host.
n=1
: PASSTHRU mode will echo all host received data and will not pass the
data to the modem while the modem is not asserting DCD.
Note:
If the modem is asserting DCD, data will be passed from the host to the modem as it
normally is when *CSX1=0.
*PTINIT=string
Any AT Command string to be passed to the OEM module before entering
PASSTHRU mode, for example, AT&S1V1, etc.
string=AT command(s)
Summary of Contents for RLXIC-SG
Page 4: ......