Setup
Page 31 of 87
The second remote example allows a remote serial DF1 device (SLC500) to be programmed
via a PLX51-DF1-ENI across an Ethernet network.
Figure 3.23. – Remote Programming Example 2
As with the previous example it is important that the DF1 settings of the remote device match
that of the PLX51-DF1-ENI. The PLX51-DF1-ENI should be configured for Full-Duplex, and
although using the Bridge mode, no mapping entries are required.
After adding the EtherNet/IP driver in RSLinx, the PLX51-DF1-ENI will automatically appear.
For the routing to work, the EDS file must be installed, which can be uploaded from the device.
The remote serial device will appear under the PLX51-DF1-ENI’s DF1 Port in the RSLinx RSWho
browser.
Figure 3.24. – Remote Programming Example 2 – RSLinx RSWho browser
