ProSoft Technology BM GM1K Series, User Manual

Page: 12 / 101

Preface
Page 12 of 101 ProSoft Technology, Inc.
January 8, 2018
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful communications to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
 Reorient or relocate the antenna.

Increase the separation between the equipment and receiver.
 Consult the manufacturer for technical help.
This equipment has been certified to comply with the limits for a class B
computing device, pursuant to FCC Rules. In order to maintain compliance with
FCC regulations, shielded cables must be used with this equipment. Operation
with non-approved equipment or use of unshielded cables is likely to result in
interference to radio and television reception. The user is cautioned that changes
or modifications made to the equipment without the approval of the manufacturer
could void the user’s authority to operate this equipment.
1.3 Certifications
Class I Division 2, Groups A, B, C, D T4 Ex nA nC IIC T4
Class I, Zone 2, AEx nA nC IIC, T4 Gc
Tamb: -
40 ˚C to +80 ˚C
Power Supply: 9-30 Vdc Powered by Class 2 Circuit
II 3 G
ATEX Sira 15ATEX4134X Ex nA IIC T4 Gc
Tamb: -20
˚C to +80 ˚C
Power Supply: 9-30 VDC (24V Typical) 0.25A Peak, 0.20 Continuous.
Power leads to terminals must be a maximum of 1 meter in length.
IECEx SIR 15.0055X, Ex nA nC IIC, T4 Gc
Tamb: -20
˚C to +80 ˚C
Power Supply: 9-30 VDC (24V Typical) 0.25A Peak, 0.20 Continuous