Page 11 of 14
09-13-568-Rev5
2
Position 2 x Clamp Plates underneath the Crossbar for each Baseplate. Ensure the Clamp Plate holes
align with the outer Baseplate channel on either side of the Crossbar.
3
Referring to Figure 7, loosely
fi
t the Baseplates
to the crossbars. Recheck the measurements
between the insides of the Baseplates from step
1 and ensure center Baseplate channels align.
Tighten screws to 4 Nm with 6 mm Allen Key
provided and 13 mm Spanner / 13 mm Socket
Wrench or a suitable Torque Wrench.
4
Attach Straps by hooking the metal webbing
buckles from behind through the side holes on
the Baseplates.
Ensure that the buckles are sitting
fl
ush
against the Baseplate as pictured, that the
Velcro section of the Adjuster Strap is facing
forward and that the Velcro section of the
Fixed Strap is facing backward.
Repeat steps for other Baseplate.
Note - Your crossbar spacing and track size
will determine where in the outer Baseplate
channels to secure to the crossbars to obtain
the recommended distance.
M8 Washer
M8 Socket Head
Capscrew 45 mm
M8 Washer
M8 Nyloc Nut
Clamp Plate
Fig. 7
5
Fit Recovery Tracks by positioning
the cross-hairs on your Tracks into
the cross slots in the Baseplates.
Fit Adjuster Straps through cam
buckles, pull to tighten
fi
rmly and
secure the Velcro sections.
