Page 9 of 14
09-13-568-Rev5
Check crossbar spread is between 492 mm to 892 mm. Position Baseplates on to separate crossbars
noting the narrow ends face towards the front and rear of the vehicle.
Set the distance between the inside of the Baseplates according to your Recovery Track type:
TRED 800 = 235 mm
TRED 1100 / MAXTRAX MKII = 440 mm
1
Installation directly onto Prorack S-Wing and International T-Slot Crossbars
440 mm
235 mm
Baseplate Channels
Baseplate Channels
Note the approximate positions on
the Baseplate channels that align
with the channels in the crossbars.
Push rubber in
fi
ll down and slide 3x M8 T-Nuts into each crossbar channel in the positions under the
Baseplate channels noted in the previous step.
The 6 mm Allen key can be used to assist T-Nut installation into the channel.
2
Note - Your crossbar spacing and
track size will determine where in the
Baseplate channels to secure to the
crossbars to obtain the recommended
distance.
Referring to Figure 6, loosely
fi
t 2x Baseplates to the M8 T-Nuts in the crossbars.
Recheck the measurements between the insides of the Baseplates from step 1 and ensure center
Baseplate channels align.
Tighten screws to 4 Nm with 6 mm Allen Key provided or a suitable Torque Wrench.
3
M8 Washer
M8 Spring Washer
M8 Socket Head
Capscrew 16 mm
Fig. 6
