PRONAR PUV-3600HD, Operator'S Manual

Page: 48 / 83

PUV-3600HD / PUV-4000HD SECTION 4
4.10
plough's solenoid valve and to the cigarette lighter socket in the carrying vehicle. Place the
switch (3) in an accessible place in the operator cab. Arrange electrical wires and hydraulic
conduits so as to prevent their damage during operation.
ATTENTION
During operation, the connecting cables should be routed so that they do not get
entangled in moving machine parts.
4.4 SNOW PLOUGH OPERATION
4.4.1 LEVELLING THE SNOW PLOUGH BODY
For optimum operation, set the snow plough body at the angle of 90
0
to the ground surface.
Levelling of the snow plough in the carrying vehicles with three-point linkage is done by
adjusting the central link (FIGURE 4.5)
FIGURE 4.5 Levelling the snow plough body suspended on three-point linkage
In the carrying vehicles equipped with extension arms (e.g. front loaders), levelling of the
snow plough is done by proper positioning of implement mounting frame (FIGURE 4.6)
The swing linkage of the snow plough must be set so that when the snow plough rests on the
ground the range of the snow plough body movement relative to the linkage during ground
surface tracking is 2/3 down and 1/3 up of the total stroke (FIGURE 4.6).
When working with the swing linkage snow plough, make sure that the carrying vehicle
linkage is fixed; do not work in a floating position. The carrying vehicle's extension arm must
not exert load on the plough during work.