Maintenance
Owner's Periodic Maintenance Guide
Troubleshooting
No LEDs turn on when Plugged in.
1. Check for AC power
a. Check AC power quality by using a lamp or similar appliance to verify:
i. The GFCI has not tripped.
ii.The extension cord is of good quality with good connections.
2. If AC power quality is verified with a lamp or similar appliance and LEDs do not illuminate,
contact ProMariner.
System Check is Red
Your system has detected an internal problem and shutdown.
1. Contact ProMariner for assistance.
Red Fault LED is ON
1. Identify the bank LED that is on.
2. Check for the following on the corresponding bank for:
a. Clean and tight connections.
b. Blown fuses.
i. Visually inspect fuses or test with multimeter.
c. Reverse Polarity.
i. Verify that the red lead is connected to the positive terminal and the black lead
is connected to the negative terminal.
d. Leads are across more than one 12 volt battery.
i. Verify leads are connected to only one 12V battery.
e. Low battery voltage
i. Verify the battery voltage is above 2.5 volts DC.
3. If none of the above situations are found and the Red Fault LED is still on, contact ProMariner.
Check Fan LED is ON after Self-test
1. Disconnect the charger from AC Power.
2. Clear the fan of any obstructions or blockages.
3. If there is no obstruction, contact ProMariner.
Charger is in Auto-maintain & Red Fault LED is Pulsing
Your battery did not complete charging during a normal charge cycle.
1. Power off your charger
2. Allow batteries to rest for 1 hour
3. Power on your charger.
4. If the fault occurs again, have your battery tested.
5. If your battery is good, the charger may be undersized for your battery, contact ProMariner.
Contact ProMariner at 1-800-824-0524 from 8:30am to 5pm Eastern, by email at
[email protected], or visit us on the web at www.promariner.com
Troubleshooting
31
32
Item:
Process:
When:
Battery Electrolyte
Per battery manufacturer’s instructions, monitor, and maintain proper
levels of distilled water in each battery.
Monthly / Before and after each trip or extensive use of batteries.
Item:
Process:
When:
AC Power Cord
Visually inspect the AC power cord. Confirm ground blade is present and
all plug blades are in good condition and not bent out of place.
Monthly
Item:
Process:
When:
DC Output Wiring
Visually inspect all wiring for cuts and abrasions. Contact
ProMariner
if your
ProTournament
elite
On-Board Marine Battery Charger
needs to
be serviced.
Monthly
Item:
Process:
When:
Battery Connections
Clean and tighten all battery connections. Follow battery manufacturer's
instructions for cleaning a battery. Clean all battery terminals with a wire brush
where required and tighten all battery connections.
Monthly
Item:
Process:
When:
Mounting Hardware Inspection
Check all mounting hardware to ensure there is no loose hardware.
Tighten where required.
Monthly
