Promac SX-823DGB, Manual

Page: 8 / 53

8
Fig. A
Transportation Recommendation:
1.
Tighten all locks before operation.
2.
Always keep proper footing & balance while moving this machine, and onlya use heavy
dutyof fiber belt to lift the machine as per Fig. A.
3.
TURN OFF the power before wiring & be sure machine is properly grounded.
Overload & circuit breaker are recommended for safety wiring.
4.
Tighten 4 bolts to base holes after machine is balanced.
5.
Check carefully if the saw blade is running in counter- clockwise
direction if not, reverse the wiring per circuit diagram, then repeat
the running test.
6.
Keepmachine always out from sun, dust, wet, or raining area.
5-3.Installation:
(1)
Always Keepproper footing & balance while moving this 253kgs machine. And only
use heavy-duty fiber belt to lift the machine as per Fig. (B).
(2)
Hang the machine up, away from the floor, take away the 4 pads and assemble them
on the auxiliary stand. Fix the machine on the auxiliary stand and lock the connection
nut.
(3)
Finish removing this wooden case/crate from the machine. Unbolt the machine from
the crate bottom.
(4) Position & tighten 4 bolts into base holes properly after machine in balance.
(5) Turn off the power before wiring & be sure machine is in proper grounding.
Overload & circuit breaker is recommended for safety wiring.
(6) Keepmachine always out from sun, dust, wet, raining area.
5-4.CLEAIG & LURICATING
B Fig.B
(1)
Your machine has been coated with a heavy grease to protect it in shipping. This coating should be completely removed
before operate the machine. Commercial degreaser, kerosene or similar solvent may be used to remove the grease from
the machine, but avoid getting solvent on belts or other rubber parts.
(2)
After cleaning, coat all bright work with a light lubricant. Lubricate all points . with a medium consistency
machine oil.
6. MINIMUM ROOM SPACE FOR MACHINE OPERATION
1540 mm
610 mm
1420 mm