Promac SX-823DGB, Manual

Page: 6 / 53

6
MAKE all adjustments with the power off. In order to obtain the machine. precision and correct ways of adjustment
while assembling, the user should read the detailed instruction in this manual.
D.
WORKING ENVIRONMENT:
(1).
KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
(2).
DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in damp or wet locations, or expose them
to rain. Keep work area well-lighted.
(3).
KEEP CHILEREN AND VISITIORS AWAY. All children and visitors should be kept a safe distance from work area.
(4).
DON’T install & use this machine in explosive, dangerous environment.
E.
MAINTENANCE:
(1).
DISCONNECT machine from power source when making repairs.
(2).
CHECK DAMAGED PARTS . Before further using of the tool, a guard or other part that is damaged should be
carefully checked to ensure that it will operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired or replaced.
(3).
DISCONNECT TOOLS before servicing and when changing accessories such as blades, bits, cutters, etc. (4).
MAKE SURE that blade tension and blade tacking are properly adjusted.
(5).
RE-CHECK blade tension after initial cut with a new blade.
(6).
TO RPOLONG BLADE LIFE ALWAYS release blade tension at the end of each workday.
(7).
CHECK COOLANT DAILY Low coolant level can cause foaming and high blade temperatures. Dirty coolant can
clog pump, cause crooked. Rust, low cutting rate and permanent blade failure. Dirty coolant can cause the growth
of bacteria with ensuing skin irritation.
(8).
WHEN CUTTING MAGNESIUM NEVER use soluble oils or emulsions(oil-water mix) as water will greatly
intensify any accidental magnesium chip fire. See your industrial coolant supplier for specific coolant
recommendations when cutting magnesium.
(9).
TO PRNMT corrosion of machined surfaces when a soluble on is used as coolant, pay particular attention to
wiping dry the surfaces where fluid accumulates and does not evaporate quickly, such as between the machine bed
and vise.
F.
SPECTIFIED USAGE:
This machine is used only for general metals cutting within the range of cutting capacity.
G.
NOISE:
A weighted sound pressure level : under80 dB.
H.
SAFETY DEVICE:
Interlock switch on cutting area as soon as the cover of cutting area is open, machine will stop at once witch the
function of this switch. Do not remove this switch from machine for any reason, and check its function
frequently.
3. SPECIFICATION
Variable Speed 23~92(50HZ)/28~110(60HZ)
MOTOR
1.5HP(2-Speed)
Saw Blade Speed
FPM
138/276(60Hz) ； 115/230(50Hz)
MPM
42/84(60Hz)
；
35/70(50Hz)
Blade Size(mm) 27x0.9x2450
Dimension LxWxH (mm) 1350x700x1326
Packing
N.W / G.W (kgs) 270 / 310
Measuremen
t
1490x790x987