Promac SX-823DGB, Manual

Page: 10 / 53

10
TELLTALE CHIPS
Chips are the best indicators of correct feed force. Monitor chip information and adjust feed accordingly.
Thin or powdered chips – increase feed rate or reduce band speed.
Burned heavy chips – reduce feed rate and/or band speed.
Curly silvery and warm chips – optimum feed rate and band
speed.
9.
USE OF MAIN MACHINE PARTS
9-1.POWER SYSTEMS AND CONTROL PANEL
The electrical rating of your band saw is either with 230 volt-single phase, or 400 volt-3 phase, magnetic control.
Before connecting your machine to an electrical power system, be sure the motor shaft is running in the correct direction.
We recommend that 1.5mm² fused with a 10 amp, dual element, time lag fuse, to be used to supply power to all machines
regardless of their electrical rating.
Refer to the electrical wiring diagram supplied with your machine for instructions
on how to connect saw to power source. Power must be cut off when wheel
cover is opened or during repairing.
Please check the moving direction of the blade. If the blade is moving in the wrong direction, please re-connect the wire.
9-2-1. STARTING AND STOPPING MACHINE (cylinder system)
1.
Light (D) will be on when power is connected.
2.
Rising up the saw arm away from the saw table.
3.
Turn right Value (L) to Close hydraulic valve when in operation.
4.
Turn (K) to controlling downwards of saw arm. And control the downward speed by adjusting hydraulic
volume valve.
5.
When motor is running, turn right (K), saw arm will automatically go down and start cutting the work piece.
When the cutting is finished, push button (E) to stop the machine, lift saw arm rise up itself and close (L), to
next reset cutting.
6.
Start the motor by turning the start button (C), Push the button (E) to start blade saw.
7.
Turn (A) ( 0-close,1-open) to open the coolant system
1018,1021,1022 299 91
1026,1513 299 91
A36(SHAPES),1040
269 82
1042,1541 249 76
1044,1045 219 67
1060 199 61
1095 184 56
Ni-Cr-Mo
Alloy Steel 8615,8620,8622 239 73
4340,E4340,8630 219 67
8640 199 61
E9310 174 53
Tool Steel A-6 199 61
A-2 179 55
A-10 159 49
D-2 90 27
H-11,H-12,H-13 189 58
Stainless
Steel 420 189 58
430 149 46
410,502 140 43
414 115 35
431 95 29
440C 80 24
304,324 120 36
304L 115 35
347 110 33
316,316L 100 30
416 189 58